Interested to Buy Any Domain ? << Click Here >> for more details...
Differences between D-Latch and D flip-flop?
- 17 Answers
- 65210 Views
- AIT, Intel, Sibridge Technologies, I also Faced
- E-Mail Answers
Answer Posted / alekhya
latches are used as temperory buffers where as fliflops
used as registers
| Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
Basic Stuff related to Perl?
Let A & B be two inputs of the NAND gate. Say signal A arrives at the NAND gate later than signal B. To optimize delay, of the two series NMOS inputs A & B, which one would you place near the output?
What are the different design constraints occur in the synthesis phase?
Explain how binary number can give a signal or convert into a digital signal?
What happens if we use an Inverter instead of the Differential Sense Amplifier?
For an AND-OR implementation of a two input Mux, how do you test for Stuck-At-0 and Stuck-At-1 faults at the internal nodes? (You can expect a circuit with some redundant logic)
In the design of a large inverter, why do we prefer to connect small transistors in parallel (thus increasing effective width) rather than lay out one transistor with large width?
Differences between IRSIM and SPICE?
For CMOS logic, give the various techniques you know to minimize power consumption
Approximately, what were the sizes of your transistors in the SRAM cell? How did you arrive at those sizes?
How does the size of PMOS Pull Up transistors (for bit & bit- lines) affect SRAM's performance?
What is the difference between synchronous and asynchronous reset?
Explain Process technology? What package was used and how did you model the package/system? What parasitic effects were considered?
what is a sequential circuit?
You have a driver that drives a long signal & connects to an input device. At the input device there is either overshoot, undershoot or signal threshold violations, what can be done to correct this problem?
