why should we have to maintain pf in our site 0.9????????
Answer Posted / pillay
Power providing companies impose a penalty if the PF drops
below a particular level because it would be very expensive
for them to provide power at a low level of PF.So it is the
responsibility of the consumer to maintain the PF above that
level.
Is This Answer Correct ? | 12 Yes | 6 No |
Post New Answer View All Answers
at what base you will tell the direction of rotation of dc motors and generators?
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
How To increase Knowledge Of boliler regarding To Only Electrical Field..
What is the formuala to calculate the rating of motor protection circuit breaker
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
Hi My dear all Friends, There is a question regarding HVAC Engineering and widely used in Power Projects. Question- What is the diffrence Between REF, SEF and Differential Protection....???? Where REF - Restricted Earth Fault SEF - Senstive Earth Fault.
State angle criterion.
what is die electric strnth of transformer ?
Why arc quenching is used in Diode ?
What is the classification of hydro projects based on installed capacity?
What should be current in the Primary and secondary side of 1000KVA (11KV Supply)Transformer.?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
What is the magnetic field (coil DC ) of Turbo Expander?
i have 500 amp inductive load of motors ,,,pleas tell me how can i calculate for capacitor bank for improving my power factor to 99 .....calcullations for capacitor bank,,,,