Interested to Buy Any Domain ? << Click Here >> for more details...
a 3 phase slip ring induction motor is wound for 4 poles on
stator and 6 poles on rotor; when 3 phase balanced voltage
source at 50 hz is applied to motor it will run at
a)1500rpm b)1000rpm c)750 rpm d)zero rpm
- 13 Answers
- 25866 Views
- Essar, PSPCL, PSTCL, I also Faced
- E-Mail Answers
Answer Posted / nagaachi
hey fools
in SIM no:P IN ROTOR = no: poles in staor
what could be the speed i dont know
but i dont answer foolishness
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
How i can calculate current of cable according to ares?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
a 230v transformer with step down ratio 19:1.it has 2000turns on primary and rated 25va calculate max primary current no of secondary turns volts/turn
What is cut-off rate?
Why a tesa lamp is glow between two phase?
low frequency protection why recomend?
i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh
Why reactors use before incoming of ac vvfd drive?
We have 750KVA DG set, we want to introduce REF relay with 1250/1A,CL PS,Current transformers.The lead distance of 2.5mm copper flexible cable from CT to relay is around 5mtrs.We would like to know the knee point votage(VK) & IM calculion for CT's
How much voltage we need to apply in 33kv cable during hipot test of cable
we have an energy meter in a capacitor bank panel, So should we consider it's readings as energy consumption on daily basis. (when capacitor bank doesn't have any energy losses)
WHY NUTRAL GROUND SYSTEM USED IN 33KV SYSTEM
what is difference between earthingpits,earthing grid & earthing mess?
What OPGW is better than Microwave or PLCC???
what is calculation mathod/formaulla for deciding Size of busbar (Copper/ aluminum)for L.T. panel on Various Fault level like 50kA,25kA,10kA
