Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / pillay
Thanks mr sharma.It should had been gas instead of air in my answer but I didnt know it was hydrogen gas.Thanks again.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
What is shutdown of electrical sub station?
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
with out colour codeing on conductor how can be find what is r,what is b,what is y phases.....
Is there any question in the name of Static Switch in UPS??
what are the effects when a salient pole alternator is run at high speed like 3000 r.p.m?
What is an automatic controller?
which book to refer in electrical engineering for iocl exam & which book for general english.
Whether should be the oil level in OCTC transfomer? It should be upto winding immersed completely or should be upto tap changer s/w? How it will affect the performance of the transformer. Rating may be 33KVA
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
What is the relation between frequency and motor rpm?
why need to be maintain power factor for industrial customer?
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
