directional relay is typically used to respond in fault
condition who it can be used just as reverse power
protection which purely senes direction reversal to operate
a circuit breaker?
- 1 Answers
- 3302 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
In other words ,directional relay is employed for
tranmission lines when there are two or more parallel
feeders ,so that the heathy feeder does not trip due to the
fault in another feeder.It is also used when the
tranformers are in parallel operation to prevent reverse
power ,when the secondaries are in prallel
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How shall i select the value of capacitor or inductor in a system?
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?
what is is the potential diffrence between two phase ?
whats the application of voltage regulation? and whats the voltage regulation's device?
What the main causes of transient interruptions on Over-Head Distribution Lines?
5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch
testing of Vector Group – YNaoD II
What is error of a measurement?
. What is Electrical Life & Mechanical Life of Circuit Breaker? 2. What is Electrial Life & Mechanical Life of Magnetic Contactor? 3. What is RCD, RCCB & RCBO? 4. What is the Between defferance of RCD, RCCB & RCBO?
Why arc quenching is used in Diode ?
operation of protection relay watchdog contact?
What is meant by coupling capacitor?
Explain difference between stand by earth fault and residual earth fault protection?
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
Define phase lag and phase lead?
