Interested to Buy Any Domain ? << Click Here >> for more details...
why we use stones or rock pieces in transformer area?
- 10 Answers
- 31468 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Granite aggregate is spread around Tr plinth to 1.prevent
vegetation 2 reduce both touch and step voltages 3 provide
an antiskid surface
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.
Why is the frequency not changed during transformation of electrical energy in a transformer?
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
for 11KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV UG system what will be typical per KM "R" "L" "C" parameter.
hi i will D.E.E.E.is completed pls send rrb diploma old qustion papaer sent in my e mail. i.d.
During Starter Panel Com missing I Found The Main Incomer 40Amp MCB 10KA Trip When Motor Change Star To Delta Motor Rating 20HP BUT When We Use Same MCB To Other Motor It Does Not trip Or What Is Necessaries for Star Delta Starter MCB SFU MPCB OR MCCB And What are The Breaking Capacity of MCCB in the Motor above 15HP
What is the difference b/w fanuc alpha series 16i and 18i controller. what is stand for i
which connection is safer series or parallel?usually which connection we prefer at home?
Advantage of LT panel vs HT panel
What is principle of Floroscent tube 36watt.
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
How can we find out LT UG cable fault (size,from-4*25mm sqr to 4*300mm sqr)? How mani types UG cable faults?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
why do we put a transformer on soak before loading it
