Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between Resin Cast CT and Oil cooled
CT?
- 1 Answers
- 5934 Views
- I also Faced
- E-Mail Answers
Answer Posted / william lobo
Resin Cast CT and PTs are usually used in indoor
switchgeear 11kv or 6.6kv substations etc. whereas Oil
cooled CTs are used in outdoor substations viz 11kv or 33kv
switchyards.
Difference is that Resin cast are solid cast type. Oil
cooled are those immeresed in Transformer oil and sealed.
In larger capacity CTs where cooling is required then oil
cooled CTs are preferred.
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
Greeting to all members, How to calculate spill current when we have different ratio CT and Class for REF(Low Imp) I have 500/1A 5P20 @line side n 400/1A CL.X @ Neutral.
why to use freewheeling diode ( diode in revers bias mode) across dc coil
What is shunt voltage and u v voltage witch one best
Why can't we parallel the secondary circuits of two voltage transformers?
What are the raitings of Mcb,mccb and Acb in detail ??
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
Why derating factor os applied on Cables?
how can motor both beasrings insulation resistance can be check?
Why it is necessary to isolate fire fighting when you are taking shutdown for lv board.
how to find the Motor,s insulation Power?
how do prepare ongc exam.how is it question model.i am electrical. which part covering in electrical.tell me
why and how current drawn by battery charger depends upon the altitude where it is located?
An ISP is granted a block of addresses starting with 150.80.0.0/16. The ISP wants to distribute these blocks to 2600 customers as follows. a) 200 medium size businesses; each needs 16 addresses b) 400 small businesses; each needs 8 addresses c) 2000 households; each needs 4 addresses Design the subblocks and give the slash notation for each subblock. Find out how many addresses are still available after these allocations.
What is the basic principle of welding process?
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
