Interested to Buy Any Domain ? << Click Here >> for more details...
whats the diff b/w mpcb and mcb?weather it trips on single
phasing or not.
- 9 Answers
- 17736 Views
- Electra Power, Essar, I also Faced
- E-Mail Answers
Answer Posted / supreet virdee
Basically MPCB is used to protect motors from malfunctionng
and from overload whereas MCB does not work on three phase,
provides insufficeint protectin by only tripping the
cirrcuit.
MPCB can be used on three phases R,Y,B and provides full
protection to the motor n avoid it from burning.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
volts=230 c=10mf a=??
Usually in the L & T make MCC feeders' power circuit,we have BMR after the MAIN CONTACTOR.,can we interchange their position, keeping the control logic same???
which is the best institute for PLC,SCADA,DCS in hyderabad
33kv substation lay out details & line to line & line to earth measurements
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
why h parameter are called as hybrid parameter?
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
How you will determine the volume of oil in a particular Distribution transformer.
how to calculate the earth fault current
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
from generating station If 400v LT line length is 1000m how much voltage is drop and how do i calculate it? which cable will be use for this line?
at what base you will tell the direction of rotation of dc motors and generators?
