Interested to Buy Any Domain ? << Click Here >> for more details...
why pneumatic control signal output is use 0.2 to 1 kg/cm2
- 3 Answers
- 9622 Views
- Jindal, I also Faced
- E-Mail Answers
Answer Posted / shyam
Relation between nozzal flapper clearance and back pressure
is linear from 0.2 to 1kg/cm2 pressure range
| Is This Answer Correct ? | 21 Yes | 1 No |
Post New Answer View All Answers
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
you are on site,the plant trips,you are approached by operations,what do you do?
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
What is intrinsically safe system?
what is the calibration procedure for transweigh make weigh feeder?
What is hp & mp seperator .& what is its working principle ?
kindly sent some demo question and answer
what is diffrance between FF & SMART, explain with difination
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
How to control flow variations in magnetic flow maters..... When i will provide proper earthing?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
How it the difference between force balance system and dispalacement balance system?
What is the purpose of bypass valve across AS valve.
Explain why plc require in analog input 4-20amp & 0-10 volt?
