Why Earthin is not required in Xformer primary side when it
is in Star / star?
Answer Posted / k.prakashchandra
Eatrthing primary neutral of star/star Tr at the receiving
end is of no use for protection and safety . At sending end
neutral is earthed and it is sufficient.
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
List out the the types of Mounting Light fixture?
What type of a DC motor would you use for a lift?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
by using pump duty, how we will can calculate the motor duty(KW)? is there any standard or formula.
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
what is class of SPD and dittels of all class ?
Disadventage of cable-gland earthing if any ?
what is Fault level? why it is calculated? how will u decide same for our plant?
How to calculate main incomer rating of APFC Panel ? Let's say i want to find main incomer for 11kV, 1000kVAR Panel.
What is the abbreviation of NGT panel
Discribe type of fault in DOL and stardelta startor.
What are n circles?
What are the causes of unbalanced current on 34.5kv feeder Ia=0.05,Ib= 0.25, Ic=0.15 and In=0.27 prior to tripping current are balance?
HOW MANY TYPES OF FUSE?
Why we used 690V in ACS 800 drives.Why dont use standard voltage like 415v or 1.1Kv