Interested to Buy Any Domain ? << Click Here >> for more details...
pls send me the 10 years technical question papers of NTPC
AND BHEL
- 15 Answers
- 23454 Views
- Bhel, NTPC, ONGC, UCE, I also Faced
- E-Mail Answers
Answer Posted / manraj
can we get it or not.
if yes then pl. send me.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Why is the orifice tab provided?
How to Calibrate Flammable gas detector in field
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
Explain why plc require in analog input 4-20amp & 0-10 volt?
what is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
How to Calibrate Level Troll in field
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
if my flow is 20000 m3/h than which range of DPT i have to use????
give eg of how I/P is used in control loops
SOME OF YOUR QUESTIONS ARE NOT MAKING ANY SENSE SO TRY AND PUT IN A LITTLE BIT MORE EFFORT BEFORE YOU POST A QUESTION. WE WILL ONLY HELP THOSE WHO WE CAN SEE ARE TRYING TO HELP THEMSELVES.
Why grounding is necessary? Give example with diagram.
can we create an interrupt in plc through scada?
line up procedure for dp type flow transmitter?
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
