Interested to Buy Any Domain ? << Click Here >> for more details...
What power factor maintain you maintain at u r organisation
- 14 Answers
- 21504 Views
- Wheels India, I also Faced
- E-Mail Answers
Answer Posted / william lobo
Well so many answers to this simple question. The real
answer as per my experience is 0.85 to 0.9. The minimum
requirement by the Electricity boards is 0.8 to 0.85 or
they will charge a fine. But for industry 0.85 to 0.9 is
optimum and above this you will have to use large capacity
of Capacitor banks which is not practical. Also if
capacitors are too many than this will give leading PF and
this is not good since this leads to higher voltage and
many times has resulted in motor burning or failures, and
permature failure of electical equipment.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
State the points to be considered for selecting a particular type wiring.
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
what the Microsoft .NET framework is?
HOW CAN YOU CALCULATE PRACTICAL EFFICIENCY OF A ASYNCHRONOUS INDUCTIONMOTOR OF 7.5KW,& MOTOR IS RUNNING WITH AVOLTAGE OF 410 VOLTS,& TAKING CURENT OF 13 AMPS
What is MSL designation of a motor and same may be provided in details.
How to calculate the multiplying factor for energy meter with ct ratio given
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
11kv/433v delta/star distribution transformer primary side full load Ht current is 83.33A in , but input side VCB rating 800A.why?
What is Icu and Ics and what is difference b/w them. please tell me how to calculate a size of a copper bar for a system or a breaker... reply on... king.arish@gmail.com would be waiting for a logical answer.
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
What cmos is and its benefits?
what is meant by impulse voltage?
We have a distribution transformer of 750KVA/11kv/440v and an AVR (Servo Stabilizer) of 750KVA on the LT side of distribution transformer. Also we have an ACB of 1200A on the output of distribution transformer (that is on the input of AVR). We want to have an MCCB on the output of AVR. What should be the rating?
from where the self excitrd induction generator get the power?why is the voltage regulation is poor of seig?
in parallel operation of power transformer why the distance between power transformer and capacitor bank feeder is necessary to know
