Answer Posted / genau

Mr. Ranjan is correct!!
Fault level of the system will depend on the system impedance.

for calculation of fault level, calculate the fault impedance and hence you can calculate fault current from system voltage and fault impedance. product of two gives fault level in VA (Generally specified in MVA)

In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?

2252

---

How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).

1939

---

how to electronic energy metter failed in electomagnectic fild passing in the metter and which thing to defect more on metter.

1954

---

george phenomenon of synchronous machine

7521

---

plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in

2064

---

How vfd saving power.

2014

---

checking procedure of capacitor based motors.used in fans etc?

2091

---

all interview questions with answers of ntpc (2000-2009

2201

---

In siemens PLC, why do we want to move the data ?

2306

---

what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?

2885

---

Why can't we take NO LOAD TRIAL of motors having V1 mounting??

1905

---



2117

---

why is control bus bi-directional?

2134

---

What is size 00, 01, 1 etc., in HRC fuse types?

2355

---

What is the instrument to check the rotating diode fuse of alternator in running conditions?

2456

---