Answer Posted / rumna
a ckt breaker consists of two parts- a fixed part and a moving part. under normal operating conditions these two parts remain in contact. when fault occurs the trip coils of the ckt breaker gets energised and the moving part are pulled apart by some mechanism thereby opening the circuit.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
How many types of electric motors are there?
what is meaning of bus riser
what is ATS & RING MAIN UNIT in Distribution System?And its Function.
why we are using earth pit in sub stations.?
i need to give section engineer (electrical engineer) for RRB. Please suggest some book
how can i get the formula to find out the cable size if i know the load of main fuse protection.
how is the incoming cable size calculated for a given current rating of a panel??
Why power factor should not be in leading (capacitive) mode of any load.
What is the approximate value of stacking factor?
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
why we used dc supply for field in dg set
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
When lag/lead/lag-lead compensation is employed?
What is the relation between frequency and motor rpm?
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
