Why the meters sonnected to metering core of CT are not
damagedon event of a fault??? Explain the phenomena??
Answer Posted / k.prakashchandra
The iron core of metering CT is smaller compared to that of
protection scheme, for accuracy. Its core reaches magnetic
saturation , if the current exceeds the rated value by a
certain value. After the saturation is reached, the
secondary current wii not incease with the primary
current .
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How will polarity test of Dy5 Transformer ?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
Is better to supply the voltage for static exciter from the auxiliary power source or from the SG terminals? And why?
11000volt DG set carnt kaise banvay
Load break swicth maintenance procedure.
if a.c supply is given to the motor,, what happen?
ELECTRICAL DRIVES: can a motor load system with passive load torque can have equilibrium speed in second quadrant
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?
How to calculate the current of Highpressure Mercury Vapour Lamp?what is the basis?whether we have to consider power factor or not?
How can we increase fuel-power ratio of any DG set?
A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.
why transformer ratings in kva? & DG ratings in kva? & Motor ratings in kw/HP?
how we findout a ignater is faulty or not?
How to determine stage of Automatic Power factor controlling Relay(Apfcr)?