Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between sensor and tranducers?
- 12 Answers
- 19339 Views
- I also Faced
- E-Mail Answers
Answer Posted / antonyraj
sensor is a receiving a signal.Tranducers is a transmiting
a data a data one device to antother device.
| Is This Answer Correct ? | 9 Yes | 11 No |
Post New Answer View All Answers
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
please someone tell me what is function of vibration sencer and how many types and how to control viberation.please. my id is jimmykhan077@gmail.com
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
I need control valve ISA hand book. Is there any site to download that big book containing all the pages. Written by Paul Friedmann
How does temperature bath work? How does coil gets heated only by applying some current?
How ejector(or)evactor air pump is working in thermal power plant?
What is megering????
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
Why plc require in analog input 4-20amp & 0-10 volt?
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
