what does happen if generator frequency fall in running
condition & what should require immediately
- 4 Answers
- 5264 Views
- I also Faced
- E-Mail Answers
Answer Posted / poorna
if the generator frequency falls during running condition
it may result in circulating currents if it running in
parallel with other generators or it is connected to grid,
remedy is to increase the speed of prime mover by any means
if not possible reduce the load
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
what are the industrail measures to over ferranti effect? how would the ferranti effect the power system if those remedial mearsure arent taken? how often does this effect occurs in real power system?
concept of busbar and load dispatching..?
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
xpression 'document.FrmQF.myemail' [
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
distribution is maximum done by a)radial b)network c) parallel d)b & c
How to Design green buildings services? What is the advantage to design green building?
how electical engineer is related to apsrtc (general) post? if they ask a question in interview as why did u choose this job what shd be answer
what is the function of capacitor duty contactor in an capacitor panel???
What is given by the definition in BIL IMP/PF = 950/395 kV. This was found in a name plate of a power transformer.
Why does inductive loads consume KVARs?
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
How npn and pnp transistor works
