Interested to Buy Any Domain ? << Click Here >> for more details...
I saw one P&ID 6" control valve has been connected with 8"
process line, and 2" valve also connected in parallel with
6" valve. why the 2" valve connected in parallel, Is there
any technical reason. please clarify. With Regards-Kittu
- 5 Answers
- 10581 Views
- GNFC, I also Faced
- E-Mail Answers
Answer Posted / guest
any technical reason. please clarify. With Regards-Kittu
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Identification of control valve parts.
What is intrinsic safety mean.
how is work pressure switch& level switch?what is the principle of this?
How does your previous experience relate to the job you are applying for ?
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
what is cold loop? difference between hot and cold loop?
In apron feeder how TPH is calculated?
Why MUX JB's are using only Temperature Element in Fundation field bus?
For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
what is sil (safety integrity level
What is the use of each wire in three wire RTD
What are the uses of orifice plates?
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
