what is the difference between potential Transformers and
capacitive voltage transfoemers and where it is used?
Answer Posted / amit khamesra
The purpose of VT and CVT in EHV system is same ie. to step
down the EHV to low voltage for measurement and protection
purpose. The extra function which CVT performs is to trap
the high voltage signals from the line which are used for
PLCC communication.
Is This Answer Correct ? | 19 Yes | 1 No |
Post New Answer View All Answers
The D.C. spark test is applicable to single conductor cable & assemblies of insulated single conductor cables without insulation shield,metallic sheath or metalic armor?
what is RFCT and Insulgard Relay & It's function?
What do you mean by the zone of protection?
how the CT and PT is connected in the circuit during testing of transformer explain with diagram
What is kirchoff ’s current law (kcl)?
In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
What is the estimated total hydropower potential of india?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
How can we measure earthing resistance test (Earth meggar) of Transformer neutral pit while in live condition?.
Grid fault level [KA]?
what is mean by dry frequency