Interested to Buy Any Domain ? << Click Here >> for more details...
What is the diffirence between Earth and Neutral
and What is the required normal voltage between earth and
neutral
- 6 Answers
- 11198 Views
- I also Faced
- E-Mail Answers
Answer Posted / shahul
Re: What is the diffirence between Earth and Neutral and
What is the required normal voltage between earth and
neutral
Answer
# 1 through earth current goes to earth, but through
neutralv
current goes to neutral point of supplier. voltage diff. is
zero
Is This Answer Correct ? 4 Yes 0 No
0 Prahalad Prajapat
Re: What is the diffirence between Earth and Neutral and
What is the required normal voltage between earth and
neutral
Answer
# A little more clarification in Prahlads answer:
While 'earth' is the universal ground, 'neutral' is the
local ground of a circuit or a loop.
Secondly, 'neutral' completes the circuit whereas 'earth'
is not meant for this.
# The voltage difference should be idealy zero but
practically it depends upon application. Normally it should
not be more than 5 Volts.
A little more clarification in Prahlads answer:
While 'earth' is the universal ground, 'neutral' is the
local ground of a circuit or a loop.
Secondly, 'neutral' completes the circuit whereas 'earth'
is not meant for this.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
pls give me presant awerness quistion and answer in my emailid.
please send data bank of quetions answers on analytical instrumentation.
how to calibrate steam control valve in steam turbine
draw shematic diagram of c/v positioner(smart type)?
How to find out the current of two motors having same power consumption but different RPM?
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
In turbine what does term CDP, NH, HSSOC means.
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
what is span value and zero ? and how set ?
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
Explain bernoulli’s theorem.
why is an oxygen sensor used in a boiler stack
What is loop1 and loop2 in MTS LT?
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
