What is the formula for finding fault level of generator?
- 11 Answers
- 35165 Views
- I also Faced
- E-Mail Answers
Answer Posted / sham
kva/1.73* voltage* % of impedance
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
Why field rheostat is kept in minimum position while armature rheostat at maximum position?
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
Explain about Leakage Test.
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
In a synchronous motor. if start is running at high speed. What will be the starting torque : Higher Lower Zero
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
What are the two basic types of transformers?
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
Why the moulded plug comes with domestic appliances instead of assembled plug like anchor, Vinay 5/15 A.
what's prime importance of protection in electrical system.if protection system don't work properly what can happen in electrical system?
what is the chemical name and formula of refrigarent R-134a.
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
