Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rajesh kumar
it works on the principle of seeback and peltier effect
it generates mv as output
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
Which type of diagphram use in costic line,DM water line,natural gas line,oil line?
if my flow is 20000 m3/h than which range of DPT i have to use????
How many interlocks at turbine? Plz explain briefly
what is the calibration procedure for magnetic flow meter @ onsite
Make Heater Process Logic.
i have been asked by QAFCO to appear for interview for thy post of Instrument Designer(INTOOLS)..i m engineering graduate with 5 years exp. in design engineering.Will this job profile suit me??i need all ur help n suggestions for thy same?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
need instrumentation job completed 1 year trainee ship in mnc pesticide company. now in search of job
can you send remote seal interface level transmitter calculation steps for oil water saperator.
Which topics are covered in Process Control?
what is KV and XV valve
what are the use of belew gear in general ??
ORP sensor working principle?
