suppose there is afault in transmission line connected to a
generating station, then what r the adjustments u will take
to without loss of synchronism?????
Answer Posted / guest
when the fault is detected by the relay, the circuit breaker
will open
Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
What is the high series capacitance winding on high voltage power transformer ?
I HAVE BEEN SELECTED FOR APGENCO A.E(ELECTRICAL) 2008.HOW MUCH WEIGHTAGE FOR INTERVIEW AND WRITTEN TEST.HOW I HAVE TO PREPARE. PLEASE GIVE INFORMATION IF U KNOW.WHAT ABT G.D THIS TIME.CALL RATIO 1:2
how to ctrl motor by use of ac or dc drive.plz explain evdintly
what is meant by directional earth fault and non directional earth fault? describe both.
i have 500 amp inductive load of motors ,,,pleas tell me how can i calculate for capacitor bank for improving my power factor to 99 .....calcullations for capacitor bank,,,,
solar energy light efficiency & disadvantages?
How much pf maintan in dg set in 6o% load,when Dg runnig Neutaal Earthing removed what happen.
do you have some of interview Questions in power and genrator section in general whith answers
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
how to apply b license to c license in tneb
What types of question are done for diploma students in aptitude test
How to work E.L.C.B and how to connect in circuit.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
how does a submersible pump work..?