What core magnetic balance test of transformer?
How to do this test in a three phase Star delta (star-LV,
Delta-HV) transformer?
How to measure and where to measure?
thanks and regards
Austin
- 22 Answers
- 93677 Views
- Neutech, Power Grid, TSSPDCL, I also Faced
- E-Mail Answers
Answer Posted / kunj pratap rao
Single phase Supply to 1U1V. 1V1W,1W1U
terminals turn by and induced voltage are mesured.
Meausered Voltage (v)
1U-1V 1V-1W w-1U 2N-2U 2N-2V 2N-2W
420 330 90 80 63 17
193 411 218 36 79 41
80 341 420 15 65 80
| Is This Answer Correct ? | 11 Yes | 3 No |
Post New Answer View All Answers
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
What are the Formula of computing Back up Time of 500kVA UPS with 4 Battery Banks, each bank composed of 43 pcs of Batteries 12V150Ah. How to compute the Back up Time of UPS? We have also 3X500kVA UPS running in Parallel same composition as I write above.
what is the role of transistor in Circuit?
what is value of Jin transformer
completed BE & done apprentice at tneb & having experience 6 years. want to get c license. will apprentiship & BE be helpful for getting c license. will i get any preference by showing this?
Role of active and reactive Power sharing in between two synchronized Generators, Droop Setting role ?
If any one's require of phoenix contact like( relay , termilnal block , surge protection device ) , product please contect me 09878206357 chetan verma
What is the mechanism of WTI
what is the voltage between earth to neutral in lift.
How much weight an electrical engine can pull??
What is the basic principle of welding process?
what is allowable ac mixing in dc
What is limitedly stable system?
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
