Answer Posted / yogesh raste
Power factor is an cosine of angle between voltage and
current.
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
What is the tension required for the 25000 CFM AHU belt
The moisture in air will condense at
List of equipments required foe industrial repair lab.
we specify current in case of feeder but in case of distributor voltage, why?
How efficiency of thermal plant can be improved?
What is the difference between a verilog task and verilog function?
What is the difference between rated and per unit in transformer?
Why can't we take NO LOAD TRIAL of motors having V1 mounting??
Why we are using Isolation Power Transformer inplace of commercial power transformer? What's the difference between them?
How will A Medium voltage circuit breaker(11 kV voltage level) operate under short circuit fault condition whether It is having short circuit release like Low voltage circuit breaker or relay should be given?
how we explain parallel paths armature winding?
what about the power of wattmeter at starting and loding?
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
why magnet has north and south poles only why not east and west and why we are considering as north and south poles? why cant we consider as east and west?
how to determine the cable size...pls explain me with the formula taking particular load....does the factors like impedance & short circuit rating influence the cable size, if so how....
