Interested to Buy Any Domain ? << Click Here >> for more details...
we touch other end of the tester supply, why do not get
shock?
- 7 Answers
- 15578 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / yogesh raste
Since our body resistance is very high we do not expeince a
shock.
| Is This Answer Correct ? | 2 Yes | 42 No |
Post New Answer View All Answers
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
WHY EXCITER PHASE SEQUENCE ARE OPPOSITE THAN STATOR SUPPLY PHASE SEQUENCE IN SYNCHRONOUS MOTOR >
Write the force balance equation of m ideal mass element.
i want to apper for apgenco or aptransco or related can any one sugest me where can i get previous papers of thouse exams
area control error
Transformer how to maintaince a check b check c check d check
33kv Rated output avilable in market (any where in india)
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
what is the purpose that we use PLC system in power system
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
I have experienced electrical maintenance HT ,but I completed be ECE ....can I apply c license or not ???? Pls help me friend s...
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
What is the normal phase difference between the voltage and the no-load current in a transformer?
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
