why the under of transformer platform is filled with rock stones.
Answer Posted / rk
TO REDUCE THE FIRE HAZARD DURING OIL LEAKAGE OR OIL
SPILLOVER DURING ANY UTWANTED SITUATIONS FOR INSTANCES SHORT
CKT. INSIDE TRANSFORMER. OIL IS FLAMMABLE IN NATURE.
| Is This Answer Correct ? | 21 Yes | 6 No |
Post New Answer View All Answers
Make a list observation on Transformer?
What Normal(Tangent) towers and Tension(Cut-point) Towers?
How much weight an electrical engine can pull??
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
what should be the acceptrd value of winding resistance for 2.5MVA transformer
What is difference between insulating medium and fault current interruption medium in a switching device.
what are the ''pitting rings''and how cn they be controlled in a series generator
What are the parameters of water ( Water quality )to be monitored in Centralised HVAC ( water cooler chillers )
please send me previose rrb junior engineer qustion papers
Yazaki india pvt ltd interview questions qurey related
I AM GOING TO ATTEND APTRANSCO ON 26TH OCT 08.PLEASE SEND ME ANY MATERIAL OR TYPE OF QUESTIONS OR EXP QUESTIONS.
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
How much ph is maintained of water resistance starter for slipring induction motor ?