Interested to Buy Any Domain ? << Click Here >> for more details...
why the under of transformer platform is filled with rock stones.
- 10 Answers
- 23135 Views
- TNEB Tamil Nadu Electricity Board, I also Faced
- E-Mail Answers
Answer Posted / baljeet singh
To reduce the short circuit current when fault occurs in transformer
| Is This Answer Correct ? | 3 Yes | 10 No |
Post New Answer View All Answers
How they LT panel busbar size choose
how many joints are allowed in underground HT cable of 1 KM
can you send me the placement papers of electrical engg. from companis like NTPC,DRDO,IOCL,HPCL,BPCL etc.?If,plz send as soon as possible.Thanks.
Two electric lamps 40 W, 220 V each are connected in series across 220 V. What is the power consumed by the connection?
HOW TO CALCULATE HV CABLE SIZING?
how to select size of hardware for linking aluminium busbar is it depend on area of busbar or current flowing through bus bar
why did youi choose this career?
How to check the LM324 Ic
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
How to calculate cable size by using load.?? Any formula...
i applied for the ap transco please forward the freqventley asked QA
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
What is sink and source?
What is depreciation factor?
