At present how many HVDC lines are there in india
- 18 Answers
- 82261 Views
- HAL, Infosys, KSEB, Kuntham, I also Faced
- E-Mail Answers
Answer Posted / gandhi pratik
at present in india there are three operating HVDC
transmission lines(not including B-to-B)
1)chandrapur to padghe(mumbai)--(1500 MW at ±500 kV DC)
2)rihand to delhi (dadri)(1500 MW at ±500 kV DC)
3)talchar to kolar (2500 MW)
and projects in progress are:
4)ballia to bhiwadi(2500 MW)-first pole charged as of 31st
March 2010
5)Mundra-Mohindergarh(Adani group-first Indian private
HVDC)-in progress,completion by 2011 end.
6)Bishwanath/Chariali to Agra(6000 MW)-recently awarded to
ABB-BHEL
| Is This Answer Correct ? | 20 Yes | 13 No |
Post New Answer View All Answers
What is an iron loss or core loss pi?
will there be any problem by recovering slip from single phase induction motors?
how can we understand that where we have to use ac or dc coil for solenoid valve and why?what is the different between coil of ac and dc explain please.
In synchronous motor, how the field current is related to armature current..i know its inversely proportional..but concept wise...i was nt clear....pls help me...
Why it is possible to use PWM with a STATCOM and not with a conventional TCR based SVC
What are the ratings of VCB, MCB, MCCB, SF6, ACB, and OCB?
What is a dominant pole?
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
What is Load sharing of Transformer ?
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
State kirchoff current law?
i karmveer bharti persuing b.tech . plz send me syllabus and name of reference books. for preparation of section eng.
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
What is the disadvantage in proportional controller?
What is the difference between acs 550 & acs 850
