Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bala
*Need more information.
1.R u on their side like one of the team member, r
2.R u the one to lead them, r
3.R they opponent 2 u (like Site.Eng Vs QC.Eng ).
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Suggest how many column, beem, etc required for 30 mtrs x 21 mtrs width x 8mtrs height for industrial shed of ground floor. I want to know the quantity of tmt steel consumption and Concrete consumption for budgeting
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
in 100 cft = 1350 bricks in 100 cft = ? bloks
what is anchorage length,lap length and (dont remember the last one)
What is the cost of formwork for columns/beams/rcc walls also what is the cost of shuttering for roof slab at height of 25 feet
Bearing capacity of soil determined as per ASTM is to design the foundation size.what is the importance of EV1/EV2 value as per DIN .My consultant ask me to test the the soil as per din to find out this ratio to assess the compacted strength of soil ,,?? is it meaning full ??
03. a. The water cement ratio for achieving maximum strength of concrete is…… 1 b. Water/ cement is inversely proportional to-------------- 1 c. Increasing the slump decreases the strength: True / false 1
What is binding spacing of the rebars at lapping zones.
1) What is meant by C-soil in geotechnical Engineering? 2) What is Eve board? 3) What will happen when heat is applied to cement? 4) what do you understand by the lateral dimention ?
Any strength is a stress but any stress is not strength
What ingredients with% found in ppc cement??
how to calculate freeboard in under ground water tank and technical details
by which materials we can prepare circular shuttering with tentative cost of material(rate analysis)
I was once rejected for US visa in early August. But now I'm going again for interview next week. What are the chances that I will faced the same VO????
I have to conduct load test on greting cover, pressure gauge is in kg cm2, how to caluculate load on this greting cover.
