Interested to Buy Any Domain ? << Click Here >> for more details...
A motor works on 30kw.it is working on 440volts.How much
amper will be Required?
- 7 Answers
- 10746 Views
- I also Faced
- E-Mail Answers
Answer Posted / ramendra shukla
Hi Dinesh you are correct but you have made a mistake- in
place of sqr(3) there will be root squre(3)
so Power,P = under root(3) VI Cos@
or P = 1.732 VI cos@
then you are correct while your calculation are correct.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
During regenerative breaking= A rotating magnetic field is reversed B slip is positive C torque is positive D slip is negative
how ct burden,magnetising current,ratio and knee point voltage are related & derived
why asa method ZPF method is more accurate than ASA method?
What is the IS standard for MCCB to be use (As per capacity of AMP)& for ACB also.
A 400 V, 50 Hz, Δ connected synchronous generator has a field reactance of 0.1 Ω and armature resistance of 0.015 Ω. At full load, the machine supplies 1200 A at 0.8 pf lagging. Under full-load conditions, the friction and windage losses are 40 KW and the core losses are 30 KW. What is the machine’s overall efficiency? Ignore any field circuit losses.
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
i have to install a HT panel, what components, I have to use in this and what will the diagram of that diagram,please tell me each and everything.
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
ACCORDING TO IEC WHAT SHOULD BE THE MINIMUM HEIGHT OF G.I. STRUCTURE OF CT, PT, ISOLATOR, LA?
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
state working of halogen lamp?
In CTs tan delta point should be earthed , what is the reason behind it?
Whether power factor should be high or low? Why?
