Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sanjay bhushan
1. Power Cables having more size than control cables
2. power cables used for direct High voltage power.
3.Control cables used for wiring in control panels,
controling divices.
4.Power cables having more dia. than control cables.
5 Power cables requires cable terminal kit & control cables
didnt requires of it.
| Is This Answer Correct ? | 10 Yes | 4 No |
Post New Answer View All Answers
Which contains in POLE ASSEMBLY of a 11KV Kirloskar-make SF6 (Model No-FP620A12)? Will u clarify with drawing?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
What is formula calculation size cable wire ?
How two nos. 130 kw D.C motor get synchronise using D.C drive.
previous year paper of ntpc bhel for degree in electrical enng
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
What are reasond for high wattage in single phase induction motors
Graphs of measuring power and speed on dc motor
What is sink and source?
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
What are the protections for safe running of electric generator?
What are factors to be considered while we selecting the Core Balance Current Transformer for Earth fault protection
How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.
what should be correct gas pressures to be a 1.5 ac unite
What is resolution of a measurement?
