What is the main difference between the terms
instrumentation and Automation?
- 5 Answers
- 7949 Views
- I also Faced
- E-Mail Answers
Answer Posted / s inamdar
Whenever the measurement is carried out with the help of
instruments it is called Instrumentation and when with HMI
DCS or SCADA it is Automation
| Is This Answer Correct ? | 10 Yes | 7 No |
Post New Answer View All Answers
Sir,I am going to sit for IOCL written test exam. recently.Can anyone tell me the name of 'Objective type Question Book on Instrumentation Engineering ' which will help me. Pl. mail to bidyut_71@rediffmail.com / bidyut.saha2008@indiatimes.com / bidyut.saha09@yahoo.in
Explain the difference between mmwc and mmwg?
what is the process for double acting cylinder pneumatic for 32' v/v
If P will increase then what will happen with PID?
Punj lloyd is coming in our Jadavpur Universtiy campus for campus placement. Please send me some hints about the writtend exam. My email id is subratafriends@gmail.com
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
What is Positive Calibration and Negative Calibration?
how to calibrate steam control valve in steam turbine
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
How to Calibrate Temperature Switch in field
Where is wet leg is used?
what is the criteria to decide conductor size of a cable ?
how to calibrate and troubleshooting of leveltroll?
What is instrumentation measurement?
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
