sir
what is the purpose of SF6 in HT breaker and what is the
pressure should be maintain in the breaker?
- 2 Answers
- 6761 Views
- Kirloskar, I also Faced
- E-Mail Answers
Answer Posted / y ashok
sf6 breaker are used for ht voltage.
sf6 breaker (sf6 gas) are high arc quenching capacity.
sf6 breaker details:-(as per my knowledge)
voltage:132 kv
current:800a
sf6 pressure :4-5.5 kg/cm2
air pressure : 12-15.5 kg/cm2
make:cgl
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
it is in our knowledge tht right plug of supply of residential suppy system is phase n other is neutral...howevr the battery charger of mobile works in both ways...i mean it is not restricted in only one direction.ny of the holder of charger can hav phase .so y is it not lik tht phase of supply must b connected 2 phase of charger...?
What is the function of electron gun assembly used in crt?
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
I NEED RRB APTITUDE QUESTIONS AND MODEL PAPER,PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in
WHY BREAKER ARE USED IN SUBSTATIONS?
which type of questions asking for solar companies?
How to Preparation of online test
What is the distance between each insulator in 33kv transformer and how can it calculate
please forward me the type of questions which would rise while me attending to 33KV Electrical License to my mail ID:vadrevu_raghava@yahoo.co.in
How many kinds of E.L.C.B and how to work E.L.C.B
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
what is the soft starter principle? how is connection diagram? what is the procedure for checking the connection?
WHAT IS DIFFERENCE BETWEEN MANUAL CONTROL AND MAGNETIC CONTROL AND STATE ITS ADVANTAGE /DISADVANTAGE
sir i applied for hpcl(electrical).i want to know from which subjects most of the technical que will b asked.and pattern of the written test.pls help me
