Interested to Buy Any Domain ? << Click Here >> for more details...
what is basic working principle of Governer in power plant?
- 3 Answers
- 8931 Views
- I also Faced
- E-Mail Answers
Answer Posted / narendra mishra
it controls the MW generation according to the steam
flow,pressure.
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
Identification of ss fittings, pilot valves, relief valve.
Calibration of controller (pneumatic)
what is the minimum power (P=VI)to produce a spark?
selection criteria of control valve? and selection criteria of actuator explain in brief?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
How does temperature bath work? How does coil gets heated only by applying some current?
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
Explain the difference between plc and cnc?
Draw symbols of the following :
how can leve transmetter calibate in feild .and also put cv and flow plz .....
How to calibrate RC Feeder system in thermal power station?,If any instrument available to calibrate it,ple inform me. make:stock,
What is the procedure of calibration of Load cell?
what is the responsibility of an instrument commissioning supervisor
