Interested to Buy Any Domain ? << Click Here >> for more details...
Is there any interfacing sofware to build communication
between a PC and ER300P model L&T make trivector meter via
RS485 port which is available in the meter and is there any
data acquisition card available to store the acquired data
from the meter into the system
- 12 Answers
- 22595 Views
- I also Faced
- E-Mail Answers
Answer Posted / ab
I'm using this meter to study the power utilization for
several load settings in a complex theromchemical
plant.....At the begning of every measurment I want to
round off the start point of the power consumption reading
to 4 digits (ex:xxxx0000)....so that I can apply my algo on
the readings which I get at the end of my measurement.
Does any one of you know how to do it?
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is scale factor of proximitor & unit of the vibration.
What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?
Capacitance, resistance ( colour coding ), parallel & series circuits.
how to calibrate and troubleshooting of leveltroll?
What is motion balance principle?
Why mmwc unit is used?
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
What is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
How an rtd work, and what volts/current goes to a rtd to measure the resistance?
Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem
How to Calibrate Ultrasonic flow Transmitter in Field
what is the reason while warning lamp is on while the engine is cranking?
why we are using digital signals for I/O & how to measure this signals is getting or not ?
What is 3 selection available when configure the burnout protection for controller
if my flow is 20000 m3/h than which range of DPT i have to use????
