Answer Posted / s.karthik
because of the very fact that load on a system seldom
remains constant,when demand increases speed of the
alternator decreases and hence the frequency changes.
Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
The metal-enclosed switchgear and controlgear is subdivided into three types: 1. metal-clad switchgear and controlgear; 2. compartmented switchgear and controlgear 3. cubicle switchgear and controlgear. What is the main differnence between them. State some example.
brief notes on ammeters
What is the method of estamating of cable, CB,MCB ?
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
What are the section criteria for cables. Now everywhere XLPE power cable is used or PVC is also used?.
what is meant by IGBT how they differ from tyristor ?
Briefly define and explain the following different types of Pulse Amplitude Modulation (PAM) with some examples. i) 2-PAM ii) 4-PAM iii) 8-PAM iv) 16-PAM v) Quadrature Amplitude Modulation (QAM)
What is the name of the winding from which the supply is taken for load connections?
What is the typical enclosure type used for Indoor switchgear / Outdoor switchgear Units? - In Onshore / offshore Units?
Why HT 11 KV Slipring Motors are connected in star ?
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
how to find impedance , mutual indatnce in transmission lines
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
what is meant by directional earth fault and non directional earth fault? describe both.
what's the requirement of Dy11d0 connection of 3 phase transformer?what's use of it?