Interested to Buy Any Domain ? << Click Here >> for more details...
how to set the overload setting in the thermal overload
relay?? is there any calculation in that??
- 3 Answers
- 17945 Views
- I also Faced
- E-Mail Answers
Answer Posted / elango k
it is based on the charaterstic of olr
100% to flc can be set it is normal
85% to flc can be set it is sharp
because an olr starts to work 115% of flc
for eg. if a motors flc is 100 amps
i am setting 85amps , the olr starts to work
at 100amps it trips the motor
| Is This Answer Correct ? | 13 Yes | 6 No |
Post New Answer View All Answers
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
what is the difference between 50 hz freq. and 60 hz freq.? which is better and economic in them ?
Readings of ER300P Trivector meter
is that any software calculator to calculate the size of cable
how current is reverse from its normal direction during the fault?
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
block diagram of 2 ups system connected in parallel mode?
anyone knows service engineer in chennai for EDM SPARKING MACHINE.CHMER PULSE CD 60 M.pL GIVE ANY CONTACT NOS
What is highest size of HT motor like 11 kv or 33 kv,and how to make it 750 rpm.i think the size will be very big.any idea ? pl. reply..
define the non synchoronism of synchoronous machine in general g or m??
how is the incoming cable size calculated for a given current rating of a panel??
how to test power transformer.YNd11
Define resonant frequency?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
explain transformer ct connection?
