Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE DIFFERENCE BETWEEN PLC AND DCS
- 55 Answers
- 129115 Views
- ABB, Adani, Adani Power, GMR, IIUC, I also Faced
- E-Mail Answers
Answer Posted / k. kaja farkhan
DCS- Distributed control system controls the closed loops
with seperate discributed controllers for each and every
single loop.it is suitable for continuous process. In many
critical plants we use this DCS panels.
PLC-Programmable logic controllers are mainly used for the
batch process controls and it works according to the
programming done on it.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
What are different types of orifice plates? State their uses.
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
HI friends.I am Surya a BTech in Electronics and Instrumentation Engineering.I am going to appear Relince Industries Ltd all India writen test very soon. so plz help me by sendind the probable questions about my subject.My mail ID is surya.barik@gmail.com.
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
What is stripper & spilitter ? Diffrence in this.?
how can use ram
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
WHAT IS THE CAM POSITION IN CONTROL VALVE POSITIONER ? WHY IT IS USED?
How we calculate orifice plat size???
protection relay watchdog contact operation?
