Interested to Buy Any Domain ? << Click Here >> for more details...
difference between isolater and circuit breaker?
- 7 Answers
- 13983 Views
- Adani, I also Faced
- E-Mail Answers
Answer Posted / sagar kakade
Isolator is nothing but a switch which is used for just on
and off the circuit. Circuit breaker is also used for on
and off the circuit, but the major benifit of using circuit
breaker in place of isolator is to trip on major electrical
faults like, a) Earth fault, b) over load, c) Under
voltage / No voltage, d) Short circuit fault. and damage to
the human beings as well as the electrical machinaries like
transformers, HT/LT panels, HT/LT cables, can be prevented.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what is the method of earthing of a transformer using electrodes?
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar
what is the difference between ac motor and dc generator
Dear sir, I have completed DECE in the year 1995. I have work experience in HT and LT LINE more than five years. Now i am doing BE in EEE from rajasthan university. After completion of BE,can i apply "C" Licence sir? Please reply.
How many gap between finger contact in a.c.b. and v.cb.?
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
i want to learn control schedule for 11kv panel? can any one send the detailed control schedule?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
What is an 86-P or an 86-A trip
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
What is gain margin?
what are the industrail measures to over ferranti effect? how would the ferranti effect the power system if those remedial mearsure arent taken? how often does this effect occurs in real power system?
if the armature current in a dc generator is ac ( sinusoidal ) why doesnt the sjhape af armature mmf a sinusoidal (ni) ? armature mmf in case of a dc machine is triangular.
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
