Answer Posted / sangram patil

Parallel:- in this process you dont have concentrate on
equality of Voltage, freq & phase angle. its a simple
method of devidation, so its easly to devide load on one or
more m/cs.
Synchronisation:- in this process you have must be
conentrate on above parameters because its become direct
affect on source. it can be happen one or more equipments.
which should be done before loading the m/cs.

What is the significance of integral controller and derivative controller in a pid controller?

1167

---

Draw the wave shape of armature current in a generator subjected to a sudden three phase short- circuit at its terminals. Define various reactance of generator from this wave shape.

2219

---

what is the reqirred voltage in HT motor to get full RPM on no load test?

2065

---

state the working of discharge lamp?

2022

---

How impulse levels are calculated that for 11kV impulse is 75kvp, for 24kV impulse is 125kvp ?

2000

---

what are safety measures in /control in diesal engine/ explain them?

1786

---

In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?

2212

---

An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%

1929

---

What are IR values and what it should be for coil and for insulator

2993

---

How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.

1990

---

Mention what are the different colors on wires indicates?

1273

---

What is the main purpose of c.f.b.c.boiler

1716

---

1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?

2643

---

What are approaches to tackle sedimentation problem of reservoir?

1015

---

Define the three phase formula fuse.

1862

---