Interested to Buy Any Domain ? << Click Here >> for more details...
what u meant by shock ? whether it depends on voltage or
current
- 12 Answers
- 16131 Views
- I also Faced
- E-Mail Answers
Answer Posted / vijayakrishna
when we touch the voltage sourceor any electrical device
then short circuit is formed then current flows in our body
this is called as shock.
shock depends on voltage.
for example : supply shock
ac 220v low
ac 440 high
compare with ac single ph supply dc supply shock is high
because ac 1_ph supply is sinusoidel and dc supply is
stright line.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
how to calculate the capacitor to maintain power factor?
what are the types of electromagnetic forces developed in practical transformer?
which protection function should measure RMS value of current&DFT value of current?
What is the use of lag compensator?
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
What is a signal flow graph?
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
WHAT DO YOU MEAN THE DIFFERENT TYPE OF CURVES OF RELAY LIKE STANDARD INVERSE, VARY INVERSE, NORMAL INVERSE, LONG INVERSE ETC....
Pl.brief me any electrical major fault you have rectified.
what are the tests comes under the type test, what tests comes under routine tests.
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
what is value of Jin transformer
what is RNG in the DG synchronizing by PLC?
