Interested to Buy Any Domain ? << Click Here >> for more details...
what is the meaning of GK value(fullform) in flowmeter ?
- 3 Answers
- 24324 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / rohan g
It may be the gravity constant.As flow measurement can get
affected by altitude variation.
| Is This Answer Correct ? | 7 Yes | 6 No |
Post New Answer View All Answers
What is shielding effect?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
What is the difference between modbus,fieldbus & profibus
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com
Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?
How many interlocks at turbine? Plz explain briefly
how to check earthing,what is minum ohms for proper earthing
Why we are using reverse action in displacer types level transmitters on some Vessels?
What is instrumentation instrumentation engineering?
Square root calculation for dp flow transmitter?
how do u calibrate the vacuum transmitter if it shows more reading
what is the difference between active & reactive power?
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
