Answer Posted / mior

First and foremost, you need to know what is your required
KVAr; then, you can design the capacitor bank to suit with
your required KVAr.

The purpose of designing the capacitor bank is to correct
the power factor to the desired value. By doing so, you can
reduce the loses of power as well as reducing your
electricity bill.

The link below might help you on how to design the power
factor correction and how to design the capacitor bank.

http://guide4electricalconsultant.com/power%20factor%
20correction.html

http://guide4electricalconsultant.com/design%20cap%
20bank.html

formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?

2209

---

What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?

1455

---

Why use the vcb at high transmission system ? Why can’t use acb?

1325

---

how can i change the rotation of the AC single phase induction motor and show me by diagram

1807

---

how unidirectional torque is produced in DC motor?

6795

---

State nyquist stability criterion.

1175

---

12.5 tons a/c is their how much kva generator can recommend to the customer.

2031

---

Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?

2123

---

Is it possible to use a S1 duty class motor for crane application (S4)? If not, why?

2447

---

can i connect the two phases of scott connected transformer,if not why?

1975

---

what is ic 01,ic 06 ?is it types of cooling?

4318

---

Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.

1754

---

area control error

1737

---

why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?

1819

---

IN dc capacitive reactance is??

1397

---