what is the use of conservator in a transformer?
- 6 Answers
- 23361 Views
- L&T, TATA, Tata Motors, I also Faced
- E-Mail Answers
Answer Posted / varun
Oil filled trasformers with a conservator,an oil tank above the transformer,tend to be equipped with the bucholz relays.These are the safety devices that detect the build of te gases,acetylene,inside the transformer,due to te corona or electric arcs in the windings and switch of the supply...
Transforms without conservators usally equipped with the pressure relays wich as similar function as te buchholz relay...
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Can we convert off line transformer to on line transformer
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
How will polarity test of Dy5 Transformer ?
is the value of inductance depends upon the value of thitha in doubly excited machine??
For a three phase induction motor, what will be the effect on motor if the neutral of the system is shifted to say 20 deg.?
what are the assumptions made in swineburne's test?
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
in single phase converter, the no.of scr's conducting during overlap a)1 b)2 c)3 d)4
IN electrical field, WHAT ALL THINGS THE CUSTOMER WILL ASK WHILE ORDERING FOR LT PANEL (ALL TYPES OF LOW TENSION PANEL)
what is the ms flat constant for calculating earth mat design calculation?
what is a bus riser in power system and why it is used
Explain the operation of variable frequency transformer?
What is ST and specify its range of voltage.
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
