Interested to Buy Any Domain ? << Click Here >> for more details...
When charging a 20 MVA , 33kV/6.6kV transformer through
regulated (0-6.6 kV or 0-33 kV) source on no load , what
will be the maximum current drawn by transformer from
source and what sould be the source capacity.
- 5 Answers
- 11472 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / satya
the charging current is about 6 times the full load current
about 2000 amps but that will be for mill seconds
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
why impudance relay used for medium transmission power system? why not others?
what is transient enclosure vltage , very fast transients, very fast transient over voltages
I'm generating a pulse of 3V with frequency 80Hz (12.5ms time period) and pulse duration 0.125ms and feeding it to a transformer since i want the pulse to get amplified around 60V. At the output amplification s happening but the pulse is changed to a spike, can you tell me what could be the reason? (an ordinary transformer 220V-12V stepdown transformer is reverse connected ie. now it is 12V-220V stepup and voltage amplification happens)
explain types of electric welding and its applications
Different types of relay fault which phase sequence??
PLS MENTION QUESTIONS ASKED IN IOCL INTERVIEW FOR ELECTRICAL EGG??
Is there any specialised book to refer about fault level calculation both in MV and LV side??
What is marx circuit?
how to test the electrical panel.ht lt mcc pcc.
After taking shutdown of 11kv feeder, if you see 5kv by phasing stick in the cable side, is it possible to close earth switch in cable.
why does rotor rotets?
what is difference between speed mode and torque mode in motor?? explain in simple words please.
why ct ,cvt should be stored in a vertical position?
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
