IS HI-POT TEST DONE ON A TRANSFORMER - YES OR NO?
WHY?
- 4 Answers
- 11454 Views
- I also Faced
- E-Mail Answers
Answer Posted / erick
Yes. Hi-Pot is short for High Potential (Voltage) which
can be deadly if it leaks from the transformer. The test
itself is to see if the insulation of the transformer is
adequate considering the voltage involved. High voltage
transformers such as those little ones in Switch Mode power
supplies also are tested. Google HiPot and see all the
equipment available for this type testing
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
how to calculation increase power factor for single phase
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
What is the difference between voltages or potential difference? And what are they?
WHAT IS THE TECHNICAL SPECIFICATION OF C CURVE & D CURVE LEGRAND MAKE MCB
how technical is calculated in 11kv line and lt line
what is arc flash and what are the hazards involved
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me
which type of motor is used in automatic swing gate
What is the feedback in the control system?
(1)Can earth and be conected together (2) what is the diferent between earth & neutral
What about electrical Units. discrive in detail
Form S and "c" license application both are same? @ tneb portal
Whar is the KvA rating of 33Kv substation & actual kv rating of power generaating station.
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
