Interested to Buy Any Domain ? << Click Here >> for more details...
Which command specifies a second subinterface on serial
interface 0?
A. interface s 0.2 point-to-point
B. interface 2 s.0 point-to-point
C. suberinterface 2.s 0 point-to-point
D. interface s 0 sub 2 point-to-point
E. interface s 0.1 point-to-point sub 2
- 2 Answers
- 6582 Views
- I also Faced
- E-Mail Answers
Answer Posted / gaurav mishra
a
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Which type of transmission bus topology support?
Tell me which cable called roll-over?
Which command we give for see routing table?
Suppose a Switch interface went in error-dis mode what you will do for Troubleshooting List all Possibilities
What is default packet size of ipv6?
After how long keep alive messages exchange in eigrp?
Why subnetting is used?
What is the syntax of ipv4?
What port does rip use?
Tell me how much hold down time of eigrep protocol?
What is the key advantage of using a switches?
When we use standard access-list?
What is subnetting? Why is it used?
On which base distance vector choose best path?
Does a bridge divide a network into smaller sections?
