Interested to Buy Any Domain ? << Click Here >> for more details...
Why a starter is used for a motor?
- 50 Answers
- 146692 Views
- L&T, Nilachal Polytechnic, I also Faced
- E-Mail Answers
Answer Posted / ram
Starter is used for a motor to limit the high starting
current. During starting of a ac motor high current of upto
4-5 times the full load current.and then start/stop switch
on the motor
| Is This Answer Correct ? | 18 Yes | 13 No |
Post New Answer View All Answers
what is the relation between reactive power and power factor for the what is the limit of reactive power and power factor
How to calculate the Efficiency of Chiller
what is the criteria for selecting fuse rating in 1phase, 2phase & 3phase welding sets?
any earth foult trip the relay but in welding time not trip by earth foult
What is resistance of 50meters, 16sq.mm, single core copper cable?
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
how hazordious area is classified at an oil & gas plant and categorise suitable class of electric equipment in that area like induction motors, LCS, Lighting Fixtures Fluerescent/Flood lights Mercury& sodium lights, J.Bs, Power Cables etc
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
What are the components connected in between the power supply coming from an electric pole to HT & LT Panels in a large commercial building or how the power supply connected from Electric pole to Transformer & then to the HT & LT panels of a building? Please send me answers via mail, my id is yogiagarwal@gmail.com. If possible, please give a line diagram.
explain PV modules in solar energy generation.
Which do you think is the most significant cause of energy loss in a factory?
what is the thumb rule for determination resistance of resistor?
How is the percentage impedence of a transformer fixed at design stage???
how much excitation voltage required to generate 1mw power?
What is the effect of pd controller on system performance?
