Interested to Buy Any Domain ? << Click Here >> for more details...
why we use 4-20 mA for calibration of the instruments.why
we cant use 0-20 mA?
- 5 Answers
- 10951 Views
- I also Faced
- E-Mail Answers
Answer Posted / shshiki
logic zero is show no current in circuit but we use 4 mili amp for instrument is on and ready for use and lower 4 mili amp current relation with non linear ..
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
what about your moleg in pogrees with company
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
hye SAM acn u send your e mail id, so that i can solve my query through e mail?
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
what is loop1 and loop2 in MTS LT?
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
What is Cavitation in a control valve?
what is output of FOUNDATION FIELD BUS transmitter
What are different types of orifice plates?
field bus transmitter calibration procedure tell me
Why mixer nd grinder Is example of constant torque load not variable torque load ???
How the sizing of the analog signal cable is calculate?
how to relay switch sense the fault?
